Kinouwell parking barrier is installed in front of parking space. When it goes up, it can block space from being occupied. It supports 3 ways of control, A) is automatic Bluetooth USB sensor, B) App controlled C)USB sensor remote control https://www.kinouwellparking.com/product/app-bluetooth-parking-lock/
You can refer to this youtube link for the automatic up and down function. https://youtu.be/DRB10k9gLkQ
Features of Kinouwell parking lock parking space barrier
- Occupancy detection. Build in vehicle detector, real time monitor occupancy status.
- Low power consumption pure battery power. Unique low power consumption circuit design, purely battery power. Theoretically service life more than 5 years under normal use (family use, 4 times/day), no need for power grid, easy installation and save construction cost.
- Anti-collision. 180° degree front and back anti-collision. Go back if blocked when ascending and go down along hit direction.
- Unique seal design, working properly even sinking in water.
- Anti-crush. 360° degree direction anti crush, weight resistant up to 3 tons from different direction.
- Dust-proof. High degree seal design for completely dust proof.
- Protect from occupancy. Buzzer alarm and backend alarm if unauthorized park or vandalism.
- Anti-theft. Bolts are installed inside the device. High strength housing material. Without keys, it cannot open cover to dismantle key.
Bluetooth automatic parking lock
Motor working voltage: 3.6V
Battery: 3.6V-38Ah Li/SOCl2 battery
Battery life: >5 years in the frequency of 4 times per day, family use
Service life: >500,000 times
Working power: <3.6mW
Standby current: <10µA
Ascending speed: <6s
Descending speed: <4s
12. Product dimension(W*D*H): 380*440*355mm Ascending
You can also refer to this website link for our products. https://www.kinouwellparking.com/product/app-bluetooth-parking-lock/
Installation of parking lock parking barrier
The parking lock is suggested to be installed at the 1/3 in the front middle part as below pictures shows.
After positioning, some preparation need to be done before installation：
- Make ground horizontal.
- If the ground is soft, make it non soft one.
- If it is horizontal and non soft ground, then cleaning before installation.
After preparation, then please follow below step for installation.
- Put parking barrier in the right position, and make the front side towards space entry.
- Open cover, mark the 4 screw position based on hole position.
- Remove parking barrier and use drill ∅12 to dig holes with depth about 50-60mm based on the mark position.
- Clean the ground and put screws inside, then put the parking barrier in the right position. Screw and close cover, and lock it.
Should you have any inquiry, please contact us.
Guangzhou Kinouwell Technology Co.,Ltd